2012 AviationLearning.net. All Rights Reserved.
"Your Online Training Resource"
A student number is issued on first module payment please quote it for all other payments and tutor requests.
Modules not currently on line will be supplied on request.
Part 66 PURCHASE OPTIONS
PRIVATE PURCHASE £30.00 GBP
SOTECH STAFF £20.00 GBP
FEAM STAFF £20.00 GBP
ENGMA VIETNAM £20.00 GBP
5 MODULES £90.00 GBP
11 MODULES £180.00 GBP
17 MODULES £300.00 GBP
PAY THE FEE TO RECIEVE THE PASSWORD
THEN CLICK ON THE MODULE TO DOWN LOAD.
EASA PART-66 MODULE 11A : TURBINE AEROPLANE AERODYNAMICS,STRUCTURES AND SYSTEMS
11.1 Theory of Flight
11.1.1 Aeroplane Aerodynamics and Flight Controls (lvl 2)
Operation and effect of:
roll control: ailerons and spoilers;
pitch control: elevators, stabilators, variable incidence stabilisers and canards;
yaw control, rudder limiters;
Control using elevons, ruddervators;
High lift devices, slots, slats, flaps, flaperons;
Drag inducing devices, spoilers, lift dumpers, speed brakes;
Effects of wing fences, saw tooth leading edges;
Boundary layer control using, vortex generators, stall wedges or leading edge devices;
Operation and effect of trim tabs, balance and antibalance (leading) tabs, servo tabs, spring tabs, mass
balance, control surface bias, aerodynamic balance panels;
11.1.2 High Speed Flight (lvl 2)
Speed of sound, subsonic flight, transonic flight, supersonic flight,
Mach number, critical Mach number, compressibility buffet, shock wave, aerodynamic heating, area rule;
Factors affecting airflow in engine intakes of high speed aircraft;
Effects of sweepback on critical Mach number.
11.2 Airframe Structures General Concepts (lvl 2)
(a) Airworthiness requirements for structural strength;
Structural classification, primary, secondary and tertiary;
Fail safe, safe life, damage tolerance concepts;
Zonal and station identification systems;
Stress, strain, bending, compression, shear, torsion, tension, hoop stress, fatigue;
Drains and ventilation provisions;
System installation provisions;
Lightning strike protection provision;
(b) Construction methods of: stressed skin fuselage, formers, stringers, longerons, bulkheads, frames,
doublers, struts, ties, beams, floor structures, reinforcement, methods of skinning, anti-corrosive
protection, wing, empennage and engine attachments;
Structure assembly techniques: riveting, bolting, bonding;
Methods of surface protection, such as chromating, anodising, painting;
Airframe symmetry: methods of alignment and symmetry checks.
11.3 Airframe Structures Aeroplanes (lvl 2)
11.3.1 Fuselage (ATA 52/53/56)
Construction and pressurisation sealing;
Wing, stabiliser, pylon and undercarriage attachments;
Seat installation and cargo loading system;
Doors and emergency exits: construction, mechanisms, operation and safety devices;
Windows and windscreen construction and mechanisms.
11.3.2 Wings (ATA 57)
Landing gear, pylon, control surface and high lift/drag attachments.
11.3.3 Stabilisers (ATA 55)
Control surface attachment.
11.3.4 Flight Control Surfaces (ATA 55/57)
Construction and attachment;
Balancing mass and aerodynamic.
11.3.5 Nacelles/Pylons (ATA 54)
11.4 Air Conditioning and Cabin Pressurisation (ATA 21)
11.4.1 Air supply (lvl 2)
Sources of air supply including engine bleed, APU and ground cart;
11.4.2 Air Conditioning (lvl 3)
Air conditioning systems;
Air cycle and vapour cycle machines;
Flow, temperature and humidity control system.
11.4.3 Pressurisation (lvl 3)
Control and indication including control and safety valves;
Cabin pressure controllers.
11.4.4 Safety and warning devices (lvl 3)
Protection and warning devices.
11.5 Instruments/Avionic Systems
11.5.1 Instrument Systems (ATA 31)(lvl 2)
Pitot static system: altimeter, air speed indicator, vertical speed indicator;
Gyroscopic: artificial horizon, attitude director, direction indicator, horizontal situation indicator,
turn and slip indicator,turn coordinator;
Compasses: direct reading, remote reading;
Angle of attack indication, stall warning systems;
Other aircraft system indication.
11.5.2 Avionic Systems (lvl 1)
Fundamentals of system lay-outs and operation of;
Auto Flight (ATA 22);
Communications (ATA 23);
Navigation Systems (ATA 34).
11.6 Electrical Power (ATA 24)(lvl 3)
Batteries Installation and Operation;
DC power generation;
AC power generation;
Emergency power generation;
Inverters, transformers, rectifiers;
11.7 Equipment and Furnishings (ATA 25)(lvl 2)
(a) Emergency equipment requirements;
Seats, harnesses and belts.
(b) Cabin lay-out;
Cabin Furnishing Installation;
Cabin entertainment equipment;
Cargo handling and retention equipment;
11.8 Fire Protection (ATA 26)(lvl 3)
(a) Fire and smoke detection and warning systems;
Fire extinguishing systems;
(b) Portable fire extinguisher
11.9 Flight Controls (ATA 27)(lvl 3)
Primary controls: aileron, elevator, rudder, spoiler;
Active load control;
High lift devices;
Lift dump, speed brakes;
System operation: manual, hydraulic, pneumatic, electrical, fly-by-wire;
Artificial feel, Yaw damper, Mach trim, rudder limiter, gust locks sys.;
Balancing and rigging;
Stall protection/warning system.
11.10 Fuel System (ATA 28)(lvl 3)
Dumping, venting and draining;
Cross-feed and transfer;
Indications and warnings;
Refuelling and defuelling;
Longitudinal balance fuel systems.
11.11 Hydraulic Power (ATA 29)(lvl 3)
Hydraulic reservoirs and accumulators;
Pressure generation: electric, mechanical, pneumatic;
Emergency pressure generation;
Indication and warning systems;
Interface with other systems.
11.12 Ice And Protection (ATA 30)(Lvl 3)
Ice formation, classification and detection;
Anti-icing systems: electrical, hot air and chemical;
De-icing systems: electrical, hot air, pneumatic and chemical;
Probe and drain heating.
11.13 Landing Gear (ATA 32)(lvl 3)
Construction, shock absorbing;
Extension and retraction systems: normal and emergency;
Indications and warning;
Wheels, brakes, antiskid and autobraking;
Air ground sensing.
11.14 Lights (ATA 33)(lvl 3)
External: navigation, anti-collision, landing, taxiing, ice;
Internal: cabin, cockpit, cargo;
11.15 Oxygen (ATA 35)(lvl 3)
System lay-out: cockpit, cabin;
Sources, storage, charging and distribution;
Indications and warnings;
11.16 Pneumatic/Vacuum (ATA 36)(lvl 3)
Sources: engine/APU, compressors, reservoirs, ground supply;
Indications and warnings;
Interfaces with other systems.
11.17 Water/Waste (ATA 38) (lvl 3)
Water system lay-out, supply, distribution, servicing and draining;
Toilet system lay-out, flushing and servicing;
11.18 On Board Maintenance Systems (ATA 45)(lvl 2)
Central maintenance computers;
Data loading system;
Electronic library system;
Structure monitoring (damage tolerance monitoring).
11.19 Integrated Modular Avionics (ATA42)(lvl 2)
Functions that may be typically integrated in the Integrated Modular Avionic (IMA) modules are, among
. Bleed Management,
Air Pressure Control,
Air Ventilation and Control,
Avionics and Cockpit Ventilation Control,
Air Traffic Communication,
Avionics Communication Router,
Management, Circuit Breaker Monitoring,
Electrical System BITE, Fuel Management,
Landing Gear Extension and Retraction,
Tyre Pressure Indication,
Oleo Pressure Indication, Brake,
11.20 Cabin System (ATA44)(lvl 2)
The units and components which furnish a means of entering the passengers and providing communication
within the aircraft (Cabin Intercommunication Data System) and between the aircraft cabin and ground
stations (Cabin Network Service).
Includes voice, data, music and video transmissions.
The Cabin Intercommunication Data System provides an interface between cockpit/cabin crew and cabin
systems. These systems support data exchange of the different related LRUs and they are typically
operated via Flight Attendant Panels
The Cabin Network Service typically consists on a server, typically interfacing with, among others, the
- Data/Radio Communication, In-Flight Entertainment Systems
- Access to pre-departure/departure report
- E-mail/intranet/internet access,
- Passenger database,
Cabin Core System
In-Flight Entertainment System
External Communication System
Cabin Mass Memory System
Cabin Monitoring System
Miscellaneous Cabin System
MODULE 11 BOOK
FAA COMPLIANT A330 NEO AND A320 NEO 40 HOUR DIFFERENCES COURSE
ALSO GENERAL FAMILIARIZATION AND 80 HOUR RAMP AND TRANSIT COURSES
A320 AND A330 PLUS NEO SERIES, B737 PLUS MAX SERIES, B744 AND B747-8.
ONLINE, CLASSROOM OR COMBINED TO SUIT YOUR NEEDS.
Contact: David Taylor Technical Director firstname.lastname@example.org
PLEASE ENSURE YOU INCLUDE YOUR NAME,DOB,COMPANY ID, DATE COMPLETED ETC ON YOUR RETURNED FORMS OR EXAMS